Publicidad
Idiomas disponibles
Idiomas disponibles
4.2. DISPLAY SYMBOLS
A. Battery charge status 25% (<25% LED flashes / >25% LED lights up)
B. Battery charge status 50% (<50% LED flashes / >50% LED lights up)
C. Battery charge status 75% (<75% LED flashes / >75% LED lights up)
D. Battery charge status 100% (<100% LED flashes / 100% LED lights up)
E. Charging programme 12V STD / LED flashes in 1A mode, lights up in 2A mode
F. Charging programme 12V LFP / LED flashes in 1A mode, lights up in 2A mode
G. Charging programme 6V STD / LED flashes in 1A mode, lights up in 2A mode
H. Fault display - LED flashes in case of short circuit or polarity reversal
5. CHARGING PROGRAMS
In order to switch between the standard charging programs, just press the "Mode"
button briefly.
A. 12V STD / 1A (LED flashes) / 2A (LED lights up): charging programme for 12V
lead-acid batteries (wet AGM and gel batteries)
B. 12V LFP / 1A (LED flashes) / 2A (LED lights up): charging programme for 12V lithium
iron phosphate batteries (LiFePO4, LFP),
C. 6V STD / 1A (LED flashes / 2A (LED lights): lead-acid batteries (wet AGM and gel
batteries)
Ladediagramm 2 A Ladegerät:
5.1. FULLY AUTOMATIC INTELLIGENT 8-STEP CHARGING
V
1
A
Step 1/ Battery check: after selecting the charging mode, the charger checks the
status of the battery.
Schritt 1 / Batterieprüfung: Nach Auswahl des Lademodus überprüft das Ladegerät de
Batterie.
Schritt 2 / Desulfatierung: Durch das Pulsieren von Strom und Spannung wird das Sulf
Bleiplatten der Batterie gelöst, um so die maximale Batteriekapazität wiederherstellen
16
Schritt 3 / Analyse: Abschaltung des Ladestroms zur Überprüfung der Leerlaufspannun
A
B
F
E
2
3
DE |
EN
| FR | ES | PT | SE | IT | NL | DK | FI | NO | PL
C
D
H
G
4
5
7
6
8
Publicidad
