Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-270-1408.
IMPORTANT:
Any attempt to run the unit before it has
been serviced with the recommended oil will result in an
engine failure.
Remove
Generator
From
Carton
• Set the carton on a rigid fiat surface with "This Side Up"
arrows pointing upward.
• Carefully open the top flaps of the shipping carton.
• Cut down corners from top to bottom at end of carton
near wheels. Laythat side of carton down flat.
• Remove all packing material, carton fillers, etc.
• Roll the generator out of the shipping carton.
BEFORE
STARTING
THE
ENGINE
Attach
Handle
NOTE: All assembly in this section will be as if assembling
from the rear of the generator.
• Placethe handle onto the handle supports already
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure I).
Carton
Contents
Check all contents. If any parts are missing or damaged,call
the generator helpline at 1-800-270-1408.
• The generator
• Generator and engine owner's manuals
• Bottle of engine oil
• Handle
• Plastic knobs (2)
• Carriage bolts (2)
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the carriage bolts through the holes on the handle
and attach the plastic knobs.Tighten the knobs by hand
(Figure 2).
/
5
Publicidad
