Retevis RA89 Manual Del Usuario página 3

NOTE: this equipment has been tested and found to comply with the limits for a Class B digital device, and is pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and radiates radio frequency energy. If not installed and used in accordance with the instructions, it may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does harmful interference to radio or television reception, which can be determined by turning off the equipment. The user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the use's authority to operate the
equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2) This device must accept any the received interference, including interference that may cause the undesired operation.
Use Two Way Radio in the environment with the temperature between -10℃ and 40℃. Otherwise, it may damage your two way radio. It can
be operated under 2000m.
For this decision, head SAR and Body SAR were performed with the device configured in the positions according to EN62209-2:2010 and
face-up SAR was performed with the device 25mm from the phantom, and Body SAR was performed with the device 0mm from the
Phantom. Body SAR was also performed with the headset and belt clip attached and without.
Changes or modifications not expressly approved by the party responsible for compliance may void the user's authority granted by the local
government radio management departments to operate this radio and should not be made. To comply with the corresponding requirements,
transmitter adjustments should be made only by or under the supervision of a person certified as technically qualified to perform transmitter
maintenance and repairs in the private land mobile and fixed services as certified by an organization representative of the user of those
services.
Replacement of any transmitter component (crystal, semiconductor, etc.) not authorized by the local government radio management
departments equipment authorization for this radio could violate the rules.
Main Functions
• DOT-MATRIX LCD DISPLAY
• Power-on mode select able
• DTMF calling channels quick assignment
• Wide / Mid /Narrow bandwidth select-able
• 200 channels
• Dual band, dual wait, dual standby,
• Busy channel lock
• Scan: frequency and CTCSS scan
• FM radio for 24 channels storage
• Multiple types for keys lock setting
• TOT
• Remote stun/ kill/ activate
USING TIPS
Please read the following brief instructions, non-compliance with these rules may cause danger or violate the law.
• Obey the local government regulation before using this radio, improper use may violate the law and be punished.
• Turn off the radio before entering flammable or explosive areas.
• Do not charge or change the battery in flammable or explosive areas.
• Turn off the radio before getting close to the blasting zone or detonator areas.
• Do not use radio whose antenna is damaged, touching of damaged antenna will cause heat injury.
• Do not attempt to disassemble the radio; the maintenance work should be done by technical experts only.
• To avoid troubles caused by electromagnetic interference or electromagnetic compatibility, please turn off the radio in places where have
the banner "Do not use wireless equipment", such as hospitals and other healthcare places.
• In the car with an airbag, do not put the radio within the scope of the airbag deployment.
• Do not store the radio under the direct sunshine or in hot areas.
• When you transmit with the radio, keep away from its antenna at least 5cm.
• If the radio appears smelly or smoke, please shut off its power immediately and contact your local dealer.
• Do not transmit too long, otherwise, the radio may heat and hurt the user.
CHARGING BATTERY PACK
Charging Precaution
The supplied battery pack of this radio is a high-performance Li-ion with 7.4V standard voltage 2800mAh high capacity in a very compact
package. Under normal use, the battery pack may be used for approximately 300 charge cycles and more, after which operating time may
be expected to decrease. If you have an old battery pack which is displaying capacity which has become diminished, you should replace the
battery pack with a new one.
Notice:
• please do not short-circuit the battery terminals or expose them on fire. Do not disassemble the battery unauthorized.
• Charge the battery between temperature 10℃ and 45℃. The battery can not be normally charged beyond this temperature range.
• Please turn off the transceiver when you charge it. Transmitting with the transceiver in charge will affect its normal charge.
• Do not unplug the Power Adapter or battery when it is charged.
• ANI
• PTT ID
• VOX
• Battery saving
• Scrambler
• Multi-Display mode
• DTMF
• Backlight brightness setting
• COMP
• 1750Hz tone
• 2 Tone/5 Tone
• CTCSS/DCS
01