ENAR GEEL 2i Manual De Operación página 42

Machine
identification
Serial number
(S/N)
en
Machine
documentation
Expectations for
information in
this manual
4
GEEL 2i
A nameplate listing the model number, item number, revision number, and serial
number is attached to this machine. The location of the nameplate is shown above.
For future reference, record the serial number in the space provided below. You will
need the serial number when requesting parts or service for this machine.
Serial Number:
•
From this point forward, this document will refer to ENAR.
Keep a copy of the Operator's Manual with the machine at all times.
•
If you are missing any of these documents, please contact ENAR to order a
replacement or visit www.enar.es.
•
When ordering parts or requesting service information, be prepared to provide
the machine model number, item number, revision number, and serial number.
•
This manual provides information and procedures to safely operate and maintain
the above ENAR model(s). For your own safety and to reduce the risk of injury,
carefully read, understand, and observe all instructions described in this manual.
•
ENAR expressly reserves the right to make technical modifications, even without
notice, which improve the performance or safety standards of its machines.
•
The information contained in this manual is based on machines manufactured up
until the time of publication. ENAR reserves the right to change any part of this
information without notice.
•
The illustrations, parts, and procedures in this manual refer to ENAR factory-
installed components. Your machine may vary depending on the requirements of
your specific region.
PORTABLE GENERATOR