Publicidad
Idiomas disponibles
Idiomas disponibles
6.4 SERVICING THE AIR CLEANER
Procedure
en
28
GEEL 2i
A dirty air cleaner can restrict air flowing into the carburetor. To keep the carburetor in
good working conditions, please service the air cleaner periodically. If operating the
engine in extremely dust area, the job should be done more often.
NOTICE: NEVER run the engine without the air cleaner. Severe engine damage will
occur.
WARNING:
Explosion and fire hazards.
Never use gasoline or other types of low flash point solvents for cleaning the
air filter. Use only compressed air, mild detergent, and warm water.
Perform the procedure below to service the air cleaner.
1.
Remove the screw (a) and then remove the cover (b).
2.
Remove the screw (c) and then remove the air filter case (d).
3.
Remove the foam element (e).
4.
Wash the foam element in solvent and dry it.
5.
Oil the foam element and squeze out excess oil. The foam element shoul be wet
but not dripping.
NOTICE: Do not wring out the foam element when squeezing it. This could cause it to
tear.
6.
Insert the foam element into the air filter case.
NOTE: Be sure the foam element seals properly against the air filter holder to avoid air
leakage. The engine should never run without the foam; excessive piston and cylinder
wear may result
7.
Install the air filter case cover in its original position and tighten the screw.
8.
Install the cover and tighten the screws.
PORTABLE GENERATOR
Publicidad
