Publicidad
Idiomas disponibles
Idiomas disponibles
6.6 CLEANING THE MUFFLER SCREEN
Procedure
en
30
GEEL 2i
Perform the procedure below to clean the muffler screen.
WARNING:
Burn hazard. The engine and muffler become very hot during operation and require cool-
down time after the engine is stopped.
Do not touch the engine, muffler, or spark plug until the machine is cool.
1.
Remove the screws (a) and then pull outward on the areas of the cover (b).
2.
Loosen the bolt (c) and then remove the muffler cap (d), the muffler screen (e)
and spark arrester (f).
3.
Clean the carbon on the muffler screen by wire brush.
NOTICE: When cleaning, use the wire brush lightly to avoid damaging or scratching the
muffler screen and spark arrester.
4.
Pull the starter rope slowly until resistance is felt and leave the handle in this
position. This ensures that the intake and exhaust valves are closed.
5.
Store the generator in a clean, dry area.
Note: Align the spark arrester projection (g) with the hole (h) in the muffler pipe.
WARNING:
If using in areas prone to fires such as forest or woods, never use an engine without an
appropriate spark arrester.
6.
Install the muffler screen and the muffler cap.
7.
Install the cover and tighten the screws.
PORTABLE GENERATOR
Publicidad
