Descargar Imprimir esta página

ENAR GEEL 2i Manual De Operación página 70

Publicidad

Idiomas disponibles

Idiomas disponibles

6.8 CLEANING THE FUEL FILTER
Procedure
en
6.9 STORAGE
Procedure
32
GEEL 2i
Perform the procedure below to clean the fuel tank filter..
WARNING:
Gasoline is extremely flammable. Drain the fuel tank in a well-ventilated area. Do not
drain the fuel tank in an area with flames or sparks.
1.
Remove the screws (a), and cover (b) then drain the fuel (c).
2.
Hold and move up the clamp (d), then take off the hose (e) from the tank.
3.
Take out the fuel filter (f).
4.
Clean the filter with gasoline.
5.
Dry the filter and replace.
6.
Install the hose and clamp and open the fuel valve to check for leaks.
7.
Install the cover and tighten the screws.
Before storing the generator for a long period of time days.
Turn the knob switch to "OFF".
1.
2.
Remove the fuel tank cap, remove the filter. Extract the fuel from the fuel tank into
an approved gasoline container using a commercially available hand siphon.
Then, install the fuel tank cap.
WARNING:
Gasoline is extremely flammable. Drain the fuel tank in a well-ventilated area. Do not
drain the fuel tank in an area with flames or sparks.
3.
Start the engine and leave it running until it stops. The engine will stop in
approximately 20 minutes.
NOTE: Do not connect with any electrical devices. (Unloaded operation). Duration of the
running engine depends on the amount of the fuel left in the tank.
PORTABLE GENERATOR

Publicidad

loading