Melchioni Family VESUVIO Manual De Instrucciones página 11


Although quartz radiation does not consume oxygen and thus provides particularly healthy
heating, it is always a good idea to check that the temperature in the room where the appliance
is located does not reach excessively high values that are not well tolerated by the body

Periodically check the wear of the various parts of the appliance. If damage or defects are found,
do not use it and contact qualified personnel. Pay particular attention to the wear of the power
cord

In anticipation of long periods of non-use of the appliance, it should be disconnected from the
mains and not simply switched off by means of the relative control

In case of severe temperature fluctuations, wait 30 minutes before operating the appliance
again

Use the appliance only for the intended purposes as illustrated in this instruction manual
3. CONTENTS OF THE PACKAGE
The package does not include any accessories and components other than the machine body,
as portrayed on the cover of this manual. When unpacking, check for complete integrity and
refrain from activating the appliance if there is found to be damage or missing parts. In this case,
please contact the retailer from whom it was purchased to restore the original condition of the
appliance.
4. COMMISSIONING AND FIRST START-UP
The appliance must be activated paying close attention to the position where it is placed.
Specifically, it must be checked that:

The appliance is located on a flat and stable, non-flammable surface, preferably on
inert flooring

If placed on timber flooring, check that it does not reach high temperatures after a
few minutes of use; if so, stop using the appliance

There is sufficient clearance from surrounding objects (0.5 metres to the right and left,
at least 1 metre at the front and above)

There are no objects that might collide with the appliance such as doors, sashes,
windows or other electrical appliances with moving parts

The cord is not subjected to right angles, excessive choking, overheating, immersion
and other potentially damaging circumstances

There is sufficient clearance from taps, piping, storage tanks, moisture condensers,
flower vases and downpipes to avoid any contact, even if accidental or partial, with
water or other liquids

The remaining provisions set out in chapter 2 above are satisfied
Having checked the above, set the switches to "0", then connect the power plug to a socket
installed in compliance with best practices, with a rated current of at least 10 amperes.
Press the two switches alternately, setting them to "1", and check that the respective groups of
heating elements (resistors) turn a reddish colour within 30 seconds and then start emitting
heat. If this is not the case, disconnect the appliance and contact the retailer from whom it was
purchased. To this end, consider that the left switch powers the first and third heating elements
from the top, and the right switch powers the second and fourth heating elements from the top.
10