Publicidad
Idiomas disponibles
Idiomas disponibles
USE
Button Function
The button only works when the door is open.
A
Press Briefly = Turns the Lights On/Off at maximum intensity.
Press and hold for 2 Seconds = Turns the Courtesy Lights
On/Off.
B
Only works with the Door Open.
Press briefly = Activates/Deactivates Delay mode, causing auto-
matic shutdown of the Motor and the Lighting system from any
speed with a 30' delay. It is disabled by pressing the same button
again, turning the motor off or closing the door.
Works both with the Door Closed and Open.
Press and hold for 2 Seconds = With the filter alarm triggered the
Filter Alarm is Reset, all leds flashing 3 times. These indications
are only visible when the motor is turned off.
C
Only works with the Door Open.
Press briefly = Activates speed four.
Only works with the Door Open.
Press and hold for 2 seconds = Enables/Disables the Intensive
speed. This speed is timed to run for 6 minutes. At the end of this
time the system will return to the speed set previously.
It is disabled by pressing the same button again, turning the motor
off or closing the door.
D
Only works with the Door Open.
Activates speed three.
E
Only works with the Door Open
Activates/Deactivates speed two.
Works both with Door Closed and Open with Motor + Lights =
Off.
Press and hold for 4 Seconds = Enables/disables the Keyboard
lock.
F
Only works with the Door Open.
Press briefly = Activates/Deactivates speed one.
Door Open or Closed
Press and hold for 2 Seconds = Enables/Disables the Activated
Charcoal Filter Alarm with the Motor turned off and no Filter
Alarm triggered.
Door Open
G
Press briefly = Turns the Motor off
Door Open or Closed
Press and hold for 2 Seconds with Motor and Lights Off =
Enables/Disables the Remote control.
H
Door Open = Closes the Door + Lights and Motor Off
Door Closed = Opens the Door + Lights and Motor On.
Warning: If the Door remains partially open for any reason, press
the Button to complete the opening or closing cycle.
EN
Control panel
LED button
LED Button B+ Button for the set Speed are lit.
Fixed LED button:
Indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
Flashing LED button:
Indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters. The
alarm is triggered after the Hood has been in
operation for 200 working hours.
Fixed LED button
Flashing LED button
Fixed LED button
Fixed LED button
All the LED buttons flash twice. During the Lock
the LED buttons light up in sequence.
Fixed LED button
LED button B flashes twice = Activated Charcoal
filter Alarm Activated
LED button B flashes once = Activated Charcoal
filter Alarm Deactivated
LED button goes out
LED button G + F flashes twice = Remote control
Enabled
LED button G + F flashes once = Remote control
Disabled
18
Publicidad
