Publicidad
Idiomas disponibles
Idiomas disponibles
Set-Up
Gas & Oil
NOTE: The engine is shipped without gasoline or oil in the
engine. Running the engine with insufficient oil can cause
serious engine damage and void the engine warranty.
WARNING!
equipment moving parts. Do not use a pressurized
starting fluid. Vapors are flammable.
Oil Recommendations
Before starting engine, fill with motor oil, capacity is 600 ml/20
oz. Refer to viscosity chart in Fig. 2-1 for oil recommendations.
Do not over-fill. Use a 4-stroke, or an equivalent high detergent,
premium quality motor oil certified to meet or exceed
U.S. automobile manufacturer's requirements for service
classification SG, SF. Motor oils classified SG, SF will show this
designation on the container.
20w40, 20w50
15w40, 15w50
10w40
10w30
(ºC)
-30º -20º
(ºF)
-20º
0º
NOTE: Do not use non-detergent oil or 2-stroke engine oil. It
could shorten the engine's service life.
6
Always keep hands and feet clear of
10w
20w
20
30
40
-10º 0º
10º
20º 30º 40º
20º
40º
60º 80º
100º
Figure 2-1
Checking Oil Level
NOTE: Be sure to check the oil while on a level surface with the
engine stopped.
1.
Remove the oil filler cap/dipstick and wipe the dipstick
clean. See Fig. 2-2.
Fill
between
high
and low
marks
Figure 2-2
2.
Insert the cap/dipstick into the oil filler neck, but do not
screw it in.
3.
Remove the oil filler cap/dipstick. If the level is low, slowly
add oil until oil level registers between high (H) and low (L),
Fig. 2-2.
4.
Replace and tighten cap/dipstick firmly before starting
engine.
NOTE: Do not overfill. Overfilling with oil may cause smoking,
hard starting, or spark plug fouling.
3
Oil Fill Cap/
Dipstick
Publicidad
