Publicidad
Idiomas disponibles
Idiomas disponibles
Sicherheit information
1. To reduce the risk of an electrical blow, electricity on the
protective switch or the safety box went out before starting.
2. All wiring must correspond to the NASI/NFPA 70-1999
National Electric Code and local electrical regulations. The
electrical installation must be carried out by a qualified and
approved electrician.
3. The connection box and support construction must be
assembled safely and 35 pounds (15.9 kilos) must be able
to transport reliably. Use only output boxes listed with
labeling
"Accepted for fans with a weight of £ 35 (15.9 kilos) or less."
4. The fan must be installed with a minimum distance of 2.1 m
(7 feet) from the posterior edge of the wings to the floor.
5. Do not operate the reverse switch if the fan wings are
moving. You have to turn off the fan and stop the wings
before reverse the direction of the wing.
6. Do not place objects on the road to wings.
7. To avoid lesions or damage to the fan and other objects, be
careful if you work on the fan or clean it.
8. Electrical diagrams only serve as a reference. The lighting
rates that are not delivered with the fan must be listed and
marked with the valve model that will be installed for use.
The switches must be general use switches UL. Take into
account the instructions for the appropriate installation
included in the lighting rates and the switches.
9. After the electrical connections have been made, the size
staircase must be turned up and carefully push to the plug
box. The cables must be distributed in such a way that the
ground connected driver and the device head are next to
the socket.
10. All fixing screws must be verified before installation and,
if necessary, followed.
11.Do NOT install this fan with variable speed wall control or
wall-mounted dimmer switch. It will permanently damage
the fan's transmitter and cause the fan's function to fail.
TECHNICAL INFORMATION
SKU
A569201CB
Nominal voltage
Nominal output (motor) light
120V AC
30W
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
WARNING: To reduce the risk of injury, knife supports
(also known as flanges) cannot be folded during
installation or after installation. Do not put any object on
the path of wings.
WARNING: Remove rubber motor attacks at the
bottom of the fan before mounting the wings or try
the engine.
WARNING: To avoid the risk of a fire or an electrical
blow, this fan should not be used with a semiconductor
speed controller.
WARNING: To avoid a possible electric shock, turn off
the current in the main security box before wiring. If
you feel that you do not have enough knowledge or
experience in electrical wiring, communicate with a
license electrician.
WARNING: Electrical diagrams only serve as a
reference. The optional use of an lighting rate must
be on the list and marked with this fan for use.
WARNING: To reduce the risk of fires, electrical
discharges or injuries, assemble the device in a socket
that with the inscription accepted for fans with a weight
of £ 35) or less. It is marked and use the screws
supplied with the plug.
NO Variable speed wall control
1*10W LED (Included)
A569201CB
NO Dimmer switch
Publicidad
