Gardebruk 109174 Instrucciones De Montaje página 4

MANUAL
Dear Customer,
You have made the right choice by purchasing one of our brand products. In order to enjoy the
product for as long as possible and to ensure safe handling, it is essential that you observe the
assembly and operating manual overleaf. Our products are subject to regular inspections to
ensure that they meet high quality standards and, of course, always comply with the stringent
requirements of the European Union. Even the best products are still subject to defects (for
example, due to external factors). We stand by our promise of quality and offer you the best
possible service. If a problem does arise, please contact our trained staff regarding all service
matters, complaints and technical support.
IMPORTANT!
Please read the manual thoroughly and in its entirety before using the product for the first time.
Keep this manual for future reference. Should you pass the product on in future, ensure that you
also include this manual.
ATTENTION! POTENTIAL DANGER!
Observe the safety and assembly instructions to avoid the risk of injury or damage to the product.
RISK OF SUFFOCATION!
Keep small parts and packaging material away from children!
PRODUCT MODIFICATION
Never make modifications to the product! Modifications will invalidate the warranty and the
product may become unsafe or, in the worst-case scenario, dangerous.
GENERAL SAFETY INFORMATION
Moving assemblies pose a risk of crushing and shearing. Do not perform any actions between
•
moving assemblies.
Warning In the event of a thunderstorm, unplug and disconnect the robot from the charging
•
station. The automatic lawnmower garage will not protect your device from a lightning strike.
GENERAL NOTES
We recommend the unit is set up by at least 2 persons.
•
Please note that screws should first be inserted by hand and tightened only slightly, so that
•
the screws find purchase and loosely connect the constituent parts.
Do not tighten the screws until all elements are connected in the correct way. Subsequent
•
tightening of the screws can compensate for minor discrepancies in drill holes or weld points
that can be present in hand-made products.
Ensure that this product is fully assembled before use. Check that all screws and bolts are
•
securely tightened, and monitor on a regular basis.
EN
4 www.DEUBAXXL.de