KALRIN C11-L Manual página 12

Wall Mount Installation
Having established the mounting location ensure that there is no electrical
wiring or pipe work in the area adjacent to the mounting surface (fig 1).
A. Mark the two mounting hole locations.
B. Drill holes in the positions marked.
C. Screw tight the screws into the drilled holes, and keep the steel screws
out for 4mm.
D. Insert 2PCS LR03 SIZE AAA1.5V batteries firmly into battery compart-
ment on the rear of the detector.
Fig 1
Tabletop Installation
Just place the CO alarm on the table, so that the users can see LEDS clearly.
WARNING: Installation of the apparatus should not be used as a
substitute for proper installation, use and maintenance of fuel burning
appliances including appropriate ventilation and exhaust systems.
OPERATING YOUR CO ALARM
Install batteries
This alarm is powered by 2 PCS LR6 SIZE AAA1.5V battery, open the bat-
tery compartment on the rear of the detector and install the batteries (See
fig 2-5).
PAY ATTENTION TO THE POLARITY CONNECTION AND CLOSE THE BATTERY
COMPARTMENT.
12