Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION
ASSEMBLY
Disconnect the power cable from the mains before any cleaning, maintenance or accessory
fitting operation.
Carefully unpack the appliance and check that all parts are clean, present and in good condition. If in
doubt, contact your dealer.
Assembling the transmission tubes and handle
-
Insert the upper transmission tube into the lower tube as shown in Fig. 1. Be careful to match
the hole on the top tube with the locking pin on the bottom tube. A click should be heard when
locking (A).
-
Tighten the assembly using the knurled screw (B). Before each time you start the machine,
check that this assembly has always been carried out correctly.
-
To dismantle: unscrew the knurled screw, release the lock (C), then gently pull the upper tube
away from the lower tube.
-
Then proceed to assemble the handle: see figure 3.
Unscrew the 4 Allen screws (A) on the handle support and remove the upper part of the support.
Position the handle in the bracket and secure it by screwing the top part of the bracket back on.
Power cable
1
Motor block
2
Upper transmission tube
3
Cable retaining hook
4
Tube fixing screws
5
Lower transmission tube
6
Safety guard
7
Wire cutter
8
3-tooth blade
9
Transmission box
10
Handle support
11
Handle with safety
12
switch
Control cable
13
Shoulder strap
14
Semi-automatic 2-wire
15
nylon head
Publicidad
