IPC Benz-C H 1809P Manual Del Usuario página 102

USING THE ADJUSTABLE
HEAD (Fig. 12)
The adjustable head enables
you to select a low or high
pressure jet. The pressure
is selected by rotating the
head.
High pressure pos. A.
Low pressure pos. B.
USE OF THE DOUBLE LAN-
CE (fig. 13)
The double lance allows the
operator to select a low or high
pressure jet. The pressure is
selected with the gun in pos.
1. High pressure: pos. 2.
Low pressure and detergent
intake: pos. 3.
ATTACHING THE DETER-
GENT INTAKE KIT (fig. 14)
To suck up the detergent so-
lution, fit the kit supplied onto
the water output of the high
pressure washer.
ADVICE ON USING DETERGENTS
!
Warning
This cleaner has been designed for use with the detergents
supplied or recommended by the manufacturer.
The use of other detergents or chemicals may influence the
safety of the cleaner.
1) For environmental compatibility, we recommend a reaso-
nable use of detergents, according to the instructions on the
pack.
2) From the range of recommended products, choose the
one most suited to the washing job to be done and dilute it
with water according to the instructions on the pack or in the
catalogue of the detergents most suited for the type of hot or
cold water cleaner.
3) Ask your dealer for the detergents catalogue.
English
   
FIG.12
FIG.13
FIG.14
OPERATING PHASES FOR CORRECT CLEANING WITH
DETERGENTS
1) Prepare the solution of detergent at the concentration
most suitable for the type of dirt and the surface that is to be
washed.
2) Start the cleaner, turn on the detergent tap (if present),
switch on the detergent suction control on the lance (fig. 12)
and spray the dirty surface with the diluted product, working
from bottom to top.
Let it react for a few minutes.
3) Rinse the whole surface well from top to bottom at high
pressure.
4) After using with detergent, flush out the intake circuit; place
the detergent suction hose (fig. 10) in a tank of clean water and
let the pump run for 1 minute with the dosing tap turned fully on
and the lance in detergent delivery condition.
ONLY THE OPERATIONS AUTHORIZED IN THIS IN-
STRUCTIONS MANUAL MAY BE CARRIED OUT BY THE
ALL OTHER OPERATIONS ARE FORBIDDEN.
! Danger
For maintenance of the high pressure pump, the electrical
parts and all parts with a safety function, you must apply to our
technical service centre.
The manufacturer is not liable in case of tampering, changes, in-
correct repairs or maintenance carried out on the machine by a
third person not provided with the manufacturer's authorization.
Periodically, at least once a year, have the safety devices and
the rated values checked at one of our technical service centres.
!
Danger
Disconnect the machine from the water supply before carrying
out any maintenance jobs.
Once maintenance has been completed, ensure that the closing
panels have been correctly reassembled and anchored with the
screws provided before reconnecting the cleaner to the mains.
! Warning
Never tip the water cleaner over onto the carburettor side.
RECAUTIONS AGAINST FROST
The cleaner must not be exposed to frost.
If the cleaner is left in premises where it is exposed to frost,
when work is over or for storage, antifreeze must be used to
prevent serious damage to the hydraulic circuit.
- 22 -
MAINTENANCE
USER.