IPC Benz-C H 1809P Manual Del Usuario página 105

FAULTS
The engine does not start up
The engine starts then stops after a
moment
No jet delivered.
The pump turns but does not reach the
rated pressure.
When the lance is turned on the pres-
sure falls and rises.
Insufficient detergent suction.
Presence of water in oil.
Water leaks from head.
For maintenance and/or repairs, use only original spare parts which offer the greatest characteristics of quality and
reliability. Failure to use original spare parts frees the manufacturer from all responsibility.
TROUBLE-SHOOTING
Before carrying out any operations, disconnect the cleaner.
CAUSES
No petrol
The petrol lever is in the OFF position
The engine switch is in the OFF position
No oil
Impurities in the petrol
Dirty air filter
Spark plug
Faulty water circuit connection.
Clogged water filter.
Mains tap turned off.
Detergent tap turned on.
Water intake filter blocked.
Faulty water circuit connection.
Pressure regulation valve is set at
minimum.
Lance nozzle is worn.
Detergent intake device on the lance is
turned on.
Dirty or worn valves.
The nozzle is clogged or deformed.
Insufficient supply.
No detergent in the tank.
Control on the lance not switched on.
Oil seal rings worn.
Gaskets worn.
English
IMPORTANT:
- 25 -
REMEDIES
Check
Place in the ON position
Place in the ON position
Check and top-up if required
Empty the tank and clean it
Clean
Clean
Check it.
Clean it.
Turn it on.
Turn it off.
Clean it.
Check it.
Regulate it.
Apply to our technical service centre.
Turn it off.
Apply to our technical service centre.
Clean or consult our technical service
centre.
Check it.
Fill the detergent tank.
Set the control on the lance.
Apply to our technical service centre.
Apply to our technical service centre.