Wolf RWT 1000 Instrucciones De Montaje página 20

Step 2
20
Installation instructions
Fitting the casing and stainless steel tensioning strap
- Fit the casing (item 17) and the stainless steel tensioning strap with stud (item 18).
(The tensioning strap is prefitted on the casing.)
Have the cut-out on the casing facing downward and slide the casing section
Please
underneath the casing of the preceding rotor segment.
note
- At the lower end, slot the stainless steel tensioning strap with stud onto the
threaded bar of the preceding segment and secure with nut 3d "long" M12 with
washer and spring washer (item 8).
- At the top, insert the threaded bar M12-200 (item 9) through the cross stud, the
casing hole and the hole in the strut fixing tabs. Secure with nut 3d M12 "long" with
washer and spring washer (item 8).
Stud
17
9
8
17
18
8
Stud
3065280_201804