WerkaPro 10388 Manual De Instrucciones Y Uso página 20

The appliance must be supplied via a residual current device (RCD) with a tripping current not exceeding 30
mA.
If the power tool is to be used outdoors, only use an extension cord that is specifically designed for outdoor
use and is marked as such.
Always unwind the extension cord completely.
For extension cords up to 15 metres in length, choose a 1.5 mm2 gauge.
For extension cords longer than 15 metres and less than 40 metres, choose a 2.5 mm2 gauge.
Always replace a damaged extension cord before using the tool.
Be sure to protect the extension cord from sharp objects, excessive heat, and damp or wet areas.
Stay Alert
Watch what you are doing. Use common sense. Do not use the power tool when you are tired, if you have
taken a medication that may cause drowsiness, or after consuming alcohol or drugs.
Check for damaged parts
Before using the power tool, inspect it carefully to make sure it will operate normally and perform its intended
function.
Check the alignment of moving parts to make sure they are not jammed. Inspect the tool for damaged or
missing parts. If any part is missing or damaged, have it replaced or repaired by an authorized service centre.
Inspect the power tool for any other problems that may affect its operation.
If any guard or other part of the power tool is damaged, it must be properly repaired or replaced by an
authorized service centre, unless otherwise specified in this operator's manual.
Any switch that does not function properly should be replaced by an authorized service centre.
Do not use the power tool if its ON/OFF SWITCH no longer controls its ON or OFF.
Caution
Do not attempt to modify the power tool in any way. Use of any accessory or part other than those
recommended in this manual may cause damage to the power tool and injury to the operator.
Have your power tool serviced by a qualified person.
This power tool complies with national and international safety requirements and standards. Only qualified
persons are allowed to carry out repairs, and only using original parts. Failure to comply with this requirement
may expose the user to considerable danger.
Fire precautions
When using certain power tools inside your home or workshop, you must observe a number of fire precautions.
As a precautionary measure, we recommend that you seek expert advice on obtaining a suitable fire
extinguisher and information on its use.
SPECIFIC SAFETY INSTRUCTIONS
Vacuum cleaner/blower
CAUTION!
Never allow children or persons who have not read and understood these instructions to use this
vacuum/blower. Do not use the vacuum/blower for any purpose other than those described in these instructions.
Study the warning labels on the appliance and replace them if they become illegible or are damaged.
Read these instructions carefully. Analyse the function of each control and learn how to use the appliance
correctly and safely.
The user is responsible for any accident affecting a third party or the property of a third party.