Broan ALLURE QS3 Serie Manual Del Usuario página 4

B N
ALLURE ® QS3 SERIES
RANGE HOOD
Page 4
PREPARE THE HOOD PREPARE THE HOOD
TOP RECTANGULAR TAPE TOP/BACK
DUCT KNOCKOUT UP TO 1" EDGE
(Remove for 3 ¼"x 10" SEMI-CIRCULAR SIDE-TO-SIDE
Vertical & for 7"Round DUCT KNOCKOUT ADJUSTMENT \
Discharge) (Remove for 7"Round
"ge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3 ¼"x 10"
Horizontal Discharge)
El Remove Duct from back of
appropriate Knockout(s_ top
or
hood.
TIES
SCREW
METAL STRIP PLATE
Horizontal Discharge Only: Remove the Plate in front of the
horizontal discharge knockout. Cut the Ties, lift plate out, and
discard plate. DO NOT REMOVE the Metal Strip held in place
with two Screws.
PIVOT -
E3
DAMPER/
DUCT
CONNECTOR
(Vertical
discharge
position shown)
3W'x 10" Ducted Discharge Only: Remove _from damper
flap and attach Damper/Duct Connector over knockout
opening with screws removed in Step 4 under "PREPARE
THE HOOD'.' Make su re damper Pivot is nearest to Top/Back
of hood.
7" Round Ducted Discharge Only: Re-install 7" Round Duct
Plate removed in Step #1 under "PREPARE THE HOOD'.'
Install a 7" round damper (purchase separately). Damper
flap must open freely in direction of airflow (away from range
hood).
[_ To accomodate off-center ductwork, the Damper/Duct
Connector can be installed up to 1-inch on either side of
hood center or the 7" Round Duct Plate can be installed
up to W' on either side of hood center. In extreme off-center
installations, one end of the duct connector may need to be trimmed
to clear the electrical cable clamp.
EDGE
[_ Non-Ducted Installations Only: Require a Performance Rinq
to be attached to the blower wheel.
To install ring:
1. Remove the Blower Wheel by rocking it side to side and
applying a slight force to pull wheel from motor. Remove _
Retaining Ring if necessary.
2. Slide the ring onto the Small Diameter End of the wheel
and down to the _ of the wheel.
3. Reassemble wheel to motor. Make sure Tab on wheel fits
into one of the Motor Slots.
4. Push wheel down until it is locked in place.
5. Check that wheel is properly positioned as shown. Press
Sections into place if necessary. Make sure wheel turns
freely.