Restraining your child in
Axkid MOVEKID car seat
Before restraining your child in the Axkid MOVEKID car seat, make sure you have the correct inlay installed in the seat. Axkid MOVEKID
is designed to grow with your child and to ensure a comfortable and safe fit for the children. Axkid recommends using the inlay until it is
too tight for your child, but to a minimum length according to table below (note that the age is just an indication):
Age
Toddler
0-3 years
Child
3-7 years
The Axkid MOVEKID is equipped with an adjustable headrest (A). See section Headrest adjustment for more information.
Adjust the headrest (A) to an approximate position for your child.
Loosen the harness by pressing the harness release button (E) and pull out both shoulder straps (S) at the same time.
Avoid pulling only one strap at the time since it may cause the shoulder straps (S) to become uneven.
Unlock the harness buckle by pressing the buckle release button (C) and place the straps outside of the seat.
Place your child in the seat and place the shoulder straps (S) over your child' s shoulders. Pull and hold the headrest
brake lever (G) to unlock and keep the headrest unlocked. Push down/pull up the headrest (A) to a position where the
shoulder straps are located maximum 1 cm above the child' s shoulders. Lock the harness by first positioning the parts
of the buckle that is attached to the shoulder straps (S) together, and then push them into the buckle until you hear a
click.
Pull on the shoulder straps (S) to tighten the harness over your child' s hips. While keeping tension in the shoulder straps
(S), pull the harness tension strap (F) straight from the car seat until the harness is tightened enough, you should not be
able to fit more than one finger between the shoulder straps (S) and your child' s shoulders.
Height
61– 105 cm
106 – 125 cm
19
19
EN