Rear Panel; Front Panel - Pioneer DDJ-SX2 Manual De Instrucciones

Rear panel

1
2
1 MASTER OUT 1 terminals
Connect powered speakers, etc., here.
2 MASTER OUT 2 terminals
Connect to a power amplifier, etc.
3 BOOTH OUT terminals
Output terminals for a booth monitor, compatible with balanced or
unbalanced output for a TRS connector.
4 MIC2 terminal
Connects a microphone here.
5 CD terminals
Connect to a DJ player or other line level device.
6 PHONO/LINE input terminals
Connect a phono level output device (analog player (for MM car-
tridges), etc.) or a line level output device (DJ player, etc.) here.
Switch the terminals' function according to the connected device
using the [INPUT SELECT] switch on this unit's front panel.

Front panel

1
1 PHONES jacks
Connect headphones here.
Both stereo phone plugs (Ø 6.3 mm) and stereo mini phone plugs
(Ø 3.5 mm) can be used.
2 HEADPHONES LEVEL control
Adjusts the audio level output from the [PHONES] jack.
3 INPUT SELECT switch
Selects the input source of each channel from the components con-
nected to this unit.
— [PC]: Select this to use the track loaded in the Serato DJ soft-
ware's deck.
— [MIC1] or [MIC2]: Select one of these to use the microphone con-
nected to the [MIC1] or [MIC2] terminal.
— [CD]: Select this to use a line level output device (DJ player, etc.)
connected to the [CD] terminals.
3 4 5 6
2 3 4
7 6 5 8
7 SIGNAL GND terminal
Connects an analog player's ground wire here. This helps reduce
noise when the analog player is connected.
8 MIC1 terminal
Connects a microphone here.
9 Kensington security slot
a
USB terminal
Connect to a computer.
b STANDBY/ON switch
This switches this unit's power between on and standby.
c DC IN terminal
Connect to a power outlet using the included AC adapter (with the
power plug mounted).
d Cord hook
Catch the AC adapter's power cord and USB cable on this hook
when using this unit.
4 3 5
4 INPUT SELECT switch
Selects the input source of each channel from the components con-
nected to this unit.
— [PC]: Select this to use the track loaded in the Serato DJ soft-
ware's deck.
— [PHONO]: Select this to use a phono level (for MM cartridges)
output device (analog player, etc.) connected to the [PHONO/
LINE] input terminals.
— [LINE]: Select this to use a line level output device (DJ player,
etc.) connected to the [PHONO/LINE] input terminals.
5 CROSS FADER CURVE selector switch
This switches the crossfader curve characteristics.
9 a b c d
9
En