Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Vacuuming Dry Materials
!
WARNING: Be sure to read, understand and apply all the information in the
Important Safety Instructions section at the beginning of this operator's manual.
Do not vacuum in areas with fl ammable gases, vapors, or explosive dusts in the
air. Flammable gases or vapors include but are not limited to: lighter fl uid,
solvent type cleaners, oil-base paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited to: coal, magnesium, grain or gun
powder. To reduce the risk of health hazards from vapors or dust, do not
vacuum toxic materials.
1
2
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. For dry vacuuming, the cartridge fi lter
must be installed correctly. To verify,
please refer to Installing Cartridge Filter
on page 10.
3. Place the power head back on the
collection tank, and secure it in place
using the latches. (Fig. 2)
4. Insert the locking end of the hose into
the vacuum port and lock in place.
(Fig. 3).
5. Choose the desired accessory and
insert onto the end of the hose. (Fig. 4)
6. Plug the power cord into the outlet.
(Fig. 5)
7. Turn the motor on by pressing the
power switch to the 'I' (ON) position
and begin vacuuming. (Fig. 6)
8. Once you have completed vacuuming,
press the power switch to the 'O' (OFF)
position and unplug the power cord
from the outlet.
3
4
DO NOT USE THE CARTRIDGE FILTER
FOR LIQUID VACUUMING.
CAUTION: Do not vacuum drywall dust,
fi replace soot or ash with standard
Wet/Dry fi lter. This is very fi ne dust
which will not be captured by the fi lter
and may cause damage to motor. To
purchase the fi ne dust fi lter, call
1-800-469-4663 or visit a Sears store.
7
5
4
6
O = OFF
I = ON
Publicidad
