Joker Active systems
are muted, the word MUTE will be shown in the main screen.
Limiter: Adjust the limiter Threshold, using UP
and DOWN arrows. Default setting is 0dB
(maximum power)
Once you are finished, press SELECT.
Polarity (only for Subwoofers): select between
positive and negative polarity (180º inversion).
It provides a very useful feature to quickly align
the subwoofers in one application.
CONFIGURATION MENU
Entering the configuration menu, the following
options can be set:
ECO Mode: Under this option, the ECO mode
can be disabled or enabled with different sleep
times.
Under the ECO mode, the system will
continuously analyze the input signal. If no
input signal is present after the number of
minutes selected in this option, the system will
go in a low power consumption mode
(standby). This condition will be indicated by a message in the LCD.
When the audio signal is present again, the system will wake up and continue
playing until the input signal is gone the next time.
If the Eco mode is selected, the word Eco will display in the main screen.
IMPORTANT: The system needs about 2 seconds to wake up from the low power
consumption mode. It is not recommended to use it for time-critical applications.
Front
LED: Joker active cabinets are
equipped with a front led, that lights up when
the cabinet is powered on.
The behaviour of the front LED can be
changed here:
Off: The front led remains always off
On: The front led remains always on
On when Limiting: The front led is normally off and lights up when either of the
limiters are active.
Off when Limiting: The front led is normally on and turns off when either of the
limiters is active (the default setting):
IMPORTANT: In the default setting, the Font Led will be lit Off when either of the
limiters is active.
33
Limiter
-3.0 dB
Polarity
Positive
Negative
Back
ECO Mode
Disabled
Enable in 1m
Enable in 10m
Enable in 30m
Back
Front LED
Off
On
On when Limiting
Off when Limiting
Back
Oct 2015
.
.
.
Amate Audio