Publicidad
Idiomas disponibles
Idiomas disponibles
4. Connect one end of a connection cable
EN
mask connector
5. Connect one end of the other connection cable to the
neck mask connector
6. Attach the hub to the charging port
The face mask and neck mask can be used separately.
In this case, directly connect the mask to the controller
with a connection cable.
7
Operation
WARNING! RISK OF INJURY!
• Be aware that the lights flicker with an
increasing speed when turning on the product.
For eye safety, first place the masks over your
face and neck before turning them on.
• When switching to another mode, the lights
flicker again with an increasing speed to indicate
the start of the new mode.
• Do not use the product for more than
10 minutes per session.
Clean all parts of the product before first use as
described in the chapter "Cleaning".
7.1 Preparation
1. Fully charge the product and properly attach the elastic
straps (see chapter "Charging" and "Assembly").
2. Thoroughly clean and dry your face and neck. Make sure
they are free from any make-up or dirt.
3. Sit or lie down and place the masks over your face and neck.
4. Use the hook-and-loop fasteners on the ends of the
elastic straps to fit the face mask
comfortably on your face and neck.
The small elastic straps
your head and the large elastic straps
at the back of your head. The medium elastic straps
should be closed at the back of your neck.
11
and the other end to the hub
3
and the other end to the hub.
4
should be closed at the top of
5
to the face
8
of the controller
16
and neck mask
1
should be closed
6
.
17
.
9
2
7
Publicidad
