Eldom iss HS11 Instrucciones De Uso página 11

EN
OPERATING INSTRUCTION
HAIR CURLER HS11
GENERAL DESCRIPTION
1. Switch
2. Indicator light - operation
3. Support
4. Tip
5. Clip
6. Indicator lamp - temperature
7. Temperature regulator
8. Power cord
OPERATION
Preparing the appliance
• Before connecting the appliance to the power supply, make sure that the switch (1) is set to is in position "0"
and the temperature regulator (7) is in position "OFF".
• Place the appliance on a flat and heat-resistant surface so that it rests on the support (3).
• Once the appliance has been connected to a power supply with the parameters specified in the instructions,
switch on the appliance switch (1) - the indicator light (2) will illuminate.
• Turn the regulator (7) to the right and set the desired temperature. The indicator light (4) will start blinking
and will be on continuously when the set temperature is reached.
• To reduce the temperature, turn the control (7) to the left and set the temperature.
• To switch the appliance off, turn the control (7) to the left to the "OFF" position and then slide the switch (1)
to the "0" position.
Hair modeling
• Hair must be washed and thoroughly combed before straightening. The hair must be slightly damp or dry.
• By pressing on the lever (5), open the curling iron clamp, insert a strand of hair a few cm wide and start
modelling the hair.
• During modelling, you can hold the appliance by the non-heating tip (4).
• Do not hold hair in the appliance for more than 20 seconds at a time.
• Only comb the hair after it has cooled down.
• The operating temperature set by the user tends to change (lowered) in contact with damp hair. The
appliance continuously adjusts the temperature.
AUTOMATIC SWITCH-OFF
• For safety, the appliance has an automatic switch-off function.
• If the appliance is not used continuously for more than 60 minutes, it will automatically switch off.
• To continue using the appliance after this time, turn the control (7) to the "OFF" position and then set the
appropriate temperature.
TECHNICAL DATA
Power: 32W
Mains supply:
110-240V~ 50-60Hz
INTENDED USE
The HS11 curling iron is used for hair modelling.
11