Descargar Imprimir esta página

Haier HWO60SM2E1XH Instrucciones De Uso página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

power source.
- Do not touch the appliance with wet or damp hands or feet.
- In general the use of adaptors, multiple sockets and extension
cables is not recommended.
- In case of malfunction and/or poor operation, switch off the
appliance and do not tamper with it.
• ENSURE THAT AN ELECTRICIAN OR QUALIFIED TECHNICIAN
MAKES THE ELECTRICAL CONNECTIONS. The power supply
to which the oven is connected must conform with the laws in
force in the country of installation. The manufacturer accepts no
responsibility for any damage caused by the failure to observe these
instructions. The oven must be connected to an electrical supply
with an earthed wall outlet or a disconnector with multiple poles,
depending on the laws in force in the country of installation. The
electrical supply should be protected with suitable fuses and the
cables used must have a transverse section that can ensure correct
supply to the oven.
• CONNECTION. The oven is supplied with a power cable that should
only be connected to an electrical supply with 220-240 Vac power
between the phases or between the phase and the neutral. Before
the oven is connected to the electrical supply , it is important to
check power voltage indicated on the gauge and the setting of the
disconnector. The grounding wire connected to the oven's earth
terminal must be connected to the earth terminal of the power
supply.
• WARNING. Before connecting the oven to the power supply, ask a
qualified electrician to check the continuity of the power supply's
earth terminal. The manufacturer accepts no responsibility for any
accidents or other problems caused by failure to connect the oven
to the earth terminal or by an earth connection that has defective
continuity.
• NOTE: as the oven could require mainteinance work, it is advisable to
keep another wall socket available so that the oven can be connected
to this if it is removed from the space in which it is installed. The
power cable must only be substituited by technical service staff or
by technicians with equivalent qualifications.
EN 8

Publicidad

loading