Preparaion; Assembly Instruction - Twin-Star International 73719/23MM6072VMA Manual De Instrucciones

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts
with package contents list and diagram above. If any part is missing or damaged, do not
attempt to assemble, install or operate the product. Contact customer service for
replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors
and utility knife
ASSEMBLY INSTRUCTIONS
1. Locate the Center Left Front Panel (B), Center
Right Front Panel (C), Center Front Panel (D), and
set out face down on a scratch-free surface.
Connect the Center Left Front Panel (B), Center
Right Front Panel (C) and Center Front Panel (D)
with Connection Plate (GG), tighten Screws (EE)
through the pre-drilled holes.
Hardware Used
EE Screw
Connection Plate
GG
(pre-attached)
2. Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Left Side Panel (E) and Right Side Panel
(F) snug to the Center Front Panel (D). Make sure
the Wood Dowels are seated in the pre-drilled holes.
Connect the Left Side Panel (E), Right Side Panel (F)
and Center Front Panel (D) with Connection Plate
(GG), tighten Screws (EE) through the pre-drilled
holes.
Hardware Used
CC Wood Dowel
EE
Screw
Connection Plate
GG
(pre-attached)
Fig. 1
GG
x 2
x 2
Fig. 2
CC
x 4
F
x 2
x 2
6
EE
D
C
GG
EE
B
CC
E