Genius H7 Instrucciones De Uso página 28

GB
Child protection device
Press the Key on the device or remote control for approx. 5 seconds until a tone is heard to activate
„
the child lock. Now the control panel/remote control is no longer functional.
To deactivate the child lock, repeat this procedure until a tone is heard again.
„
Oscillation function
The oscillation function („swivel function") serves to distribute the heat more evenly and can be
switched on or off at any time during operation.
Press the key to start the oscillation function.
„
The product begins to swivel to the left and right.
„
To stop the oscillation function, press the key again.
„
Turning off the product
To end a heating operation and enter stand-by mode, press the
„
the key on the device for approx. 5 seconds.
The flashing display indicates that the unit is switching to stand-by mode. This process lasts around 60
„
seconds
To disconnect the unit from the mains, flip the switch on the lower back of the unit.
„
Change the battery
To change the remote control battery, press the latch on the back of the remote control and pull out
„
the battery compartment
Remove the old battery from the battery compartment and replace it with a new one of the same type.
„
Pay attention to the correct polarity when inserting.
Anti-tip protection
The product is equipped with an anti-tip device that automatically switches the product off or prevents it
from switching on if it is lifted or not in an upright position. The product switches to standby mode as
soon as it is placed back on solid ground and returned to an upright position.
Overheating protection
The product contains overheating protection. This automatically switches the product off in case of
overheating. As soon as the product has cooled off, it can be operated again.
Automatic switch-off function
The unit has an automatic switch-off function which activates itself after 24 hours of non-use and
switches the unit to stand-by mode.
Care and cleaning
WARNING!
Risk of electric shock
Switch the unit off and disconnect it from the mains before cleaning or user
maintenance. Allow the device to fully cool down before cleaning.
28
Instruction manual
button on the remote control or