10) After the device has cooled down, clean it thoroughly.
If overheating occurs, the device will automatically switch off. In such cases it is necessary to:
turn the thermostat knob [A] to the „MIN" position,
•
•
set the I/O [E] switch to the „O" position,
let the device cool down,
•
•
remove the black cap of the RESET button [D] and press it to restart the device.
3.5.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Avoid using excessive amounts of water or detergent to clean the device so as not to get the electrical
parts inside the housing wet.
d)
Use only mild, food-safe detergents to wash the device.
e)
After cleaning the device, all parts should be dried completely before using it again.
f)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
g)
Do not spray the device with a water jet or submerge it in water.
h)
The device must be regularly inspected to check its technical efficiency and spot any damage.
i)
Use a soft, damp cloth for cleaning.
j)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
k)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN