Dolmar TM-102.16 Manual De Instrucciones página 129

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

HOW TO USE THE MACHINE
Put the machine away in a dry place protected from weather and, if possible, cover
with a cloth (☛ 8.4).
IMPORTANT
The battery must be kept in a cool and dry place. Before a long
storage period (more than 1 month), always charge the battery, and then recharge
before using again ( ☛ 6.2.5).
The next time the machine is used, check that there are no fuel leaks from the tubes,
fuel stopcock or carburettor.
5.4.12 C
ARD PROTECTION DEVICE
The electronic card has a self-resetting protector which breaks the circuit if there is a
fault in the electrical system. It results in the stopping of the engine and an audible sig-
nal which can only be stopped by removing the key.
The circuit automatically resets after a few seconds but the cause of the fault should
be ascertained and dealt with to avoid re-activating the protection device.
IMPORTANT
To avoid activating the protection device.
– do not reverse the leads on the battery terminals;
– do not use the machine without its battery or damage may be caused to the
charging regulator;
– be careful to not cause short-circuits.
5.4.13 S
UMMARY OF THE MAIN ACTIONS TO BE CARRIED OUT WHEN USING THE MACHINE
To ...
Start the engine (☛ 5.4.1)
Go forward (☛ 5.4.2)
Brake or stop (☛ 5.4.3)
You must ...
Open the fuel stopcock, ensure that all the conditions
allowing starting are met, and then turn the key
Move the accelerator;
for mechanical drive models: push the pedal right
down, engage the gear (☛ 4.22) and then gradually
release the pedal;
for hydrostatic drive models: press the drive pedal for-
ward; (☛ 4.32);
Reduce the engine speed and press the brake pedal
31
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tm-102.16 h2Tm-102.18 hTm-102.20 h2Tm-122.22 h2

Tabla de contenido