Samsung ME11A7510 Serie Manual De Instalación página 17

D. Mount the microwave oven
NOTE
When mounting the microwave oven, thread the power cord through hole in the
bottom of the top cabinet. Keep it tight throughout Steps 1–3. Do not pinch the
cord or lift the oven by pulling cord.
FOR EASIER INSTALLATION AND
PERSONAL SAFETY, WE RECOMMEND
THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use the
handle during installation.
NOTE
• If your cabinet is metal, use the
nylon grommet in the power cord
hole to prevent the cord from being
cut.
• Filler blocks are required when
mounting this unit under any cabinet
with a recessed bottom or front
overhang. (See page 10.)
IMPORTANT: The case damage that will
occur from over tightening
screws if you do not use
filler blocks is not covered
under warranty.
IMPORTANT: Be careful not to damage
the lower Lamp Glass during
handling.
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning
Screw
Microwave Oven Top
Thickness of cabinet
Supporter
NOTE
The self-aligning screw can be installed up to 1
1. Lift the microwave, tilt it forward,
and hook the slots at the back
bottom edge onto the four lower
tabs of the mounting plate.
2. Rotate the front of the oven up
against the cabinet bottom.
3. Insert a self-aligning screw
through the top center cabinet
hole. Temporarily secure the oven
by turning the screw at least two
full turns after the threads have
engaged. (It will be completely
tightened later.) Be sure to keep
the power cord tight. Be careful not
to pinch the cord, especially when
mounting flush to the bottom of
cabinet.
NOTE
If Cabinet Thickness is
Under 1 ˝, Use Supporter.
/ / ˝
1 15
¹/ ~
16 ~ 16
/ "
15
NOTE
If Cabinet Thickness
is over 1 ˝, Remove
1 ~ 2˝ 1~
Supporter from the Self-
2"
Aligning Screw.
/ ˝ (49mm).
15
16
English 17