Bianchi E-OMNIA FX Manual Del Usuario página 8

SOLID AXLE - NUT FASTENING SYSTEM
2D
SEAT POST CLAMP/EXPANDER
WARNING!
Use caution and observe the following warnings. Failure to comply with the warnings and provisions contained in this data sheet
exempts the manufacturer from any liability.
1D
INFORMATION!
For optimum grip and to eliminate slippage between the seat post and the frame, place a sufficient amount of gripper paste on the
part of the expander that is in contact with the seat post. (the gripper paste is included with the product).
DANGER!
Always comply with the torque levels specified on the seat post/expander clamp. Failure to comply with the recommended torque
levels may lead to malfunction and cause the rider to fall.
SEAT POST
The product is compatible with 31.6 mm diameter seat posts
8
In order to assemble and remove a wheel with a solid axle hub, loosen the
lock nuts with the appropriate tools (wrenches). The e-Omnia product with
belt drive or internal gears uses this fixing system. (2D images)
The clamp/expander system provided is designed specifically for use with
the e-Omnia frame (image 1D).
Without this component, it is not possible to lock the seat post in the
desired position.
To set the saddle height, loosen the M5 screws on the seat post clamp.
The recommended torque for the clamp/expander is 6 Nm.