Symbols Shown On The Machine - Clarke FOCUS II Micro Rider Instrucciones De Uso

WARNING!
– Pay attention during machine transportation when temperature is below freezing point. The water in the
recovery tank or in the hoses could freeze and seriously damage the machine.
Use brushes and pads supplied with the machine or those specified in the User Manual. Using other
–
brushes or pads could reduce safety.
In case of machine malfunctions, ensure that these are not due to lack of maintenance. Otherwise, request
–
assistance from the authorized personnel or from an authorized Service Center.
– If parts must be replaced, use ORIGINAL spare parts from an Authorized Dealer or Retailer.
– To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of
this Manual, must be performed by authorized personnel or by an authorized Service Center.
– Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
– When WET batteries are installed on the machine, do not tilt the machine for more than 30° from the
horizontal plane to prevent the highly corrosive acid from leaking out of the batteries. If the machine must
be tilted to perform any maintenance procedure, remove the batteries.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
etc.), which are subject to standards that require disposal in special centers (see Scrapping chapter).

SYMBOLS SHOWN ON THE MACHINE

Operator's Manual - FOCUS II Micro Rider
WARNING!
Carefully read all instructions before performing any procedure on the machine.
WARNING!
Do not wash the machine with direct or pressurized water jets.
ENGLISH
5