Electra IHI HYDRIVE eBike system 20 mph Manual Del Propietário página 18

EN - 6
Press and hold the 'assist down' button on the
display unit for three seconds to enable the walk
assistance mode. After the assistance mode is
enabled, the e-bike system will start and the
e-bike will move forward slowly; keep holding
down the down button to keep the walk
assistance mode enabled.
The assistance mode will be disabled if the
following situations occur:
- The bicycle speed exceeds 4 mph.
- The wheels of the bicycle stop turning (for
example: using the brakes or running into an
obstacle while walking with the bicycle)
5. Setting the assistance level
The assistance level can be changed on the display
unit at any time, even when you are riding.
Use extreme caution if operating the display
unit while riding.
Note:
The Hydrive e-bike system has three pre-set levels
of assistance available for riders:
Press the up and down buttons on the display unit
to enable or disable motor assistance.
The system will start in Mode 0 when initially
turned on.
If you want to increase the assistance of the
e-bike system, quickly press the up button until
desired assistance level is reached and
illuminated on the display unit; if you want to
decrease the assistance, quickly press and
release the down button until the desired
assistance level is reached and illuminated on
the display unit.
16
Display unit