GreenWorks GD48AB Manual Del Operario página 5

EN
1 DESCRIPTION
1.1 PURPOSE
The machine is used to propel air out of a tube to
move unwanted materials such as leaves in the yard.
1.2 OVERVIEW
Figure 1 - 4.
Trigger
1
Turbo button
2
Cruise control
3
lever
Tube release
4
button
2 GENERAL POWER TOOL SAFETY
WARNINGS
Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or battery-
operated (cordless) power tool.
3 INSTALLATION
3.1 INSTALL THE TUBE
Figure 2.
1. Move the tube until the lock button engages into
the slot.
2. Connect the nozzle to the tube until the latch on
the tube engages into the opening on the nozzle.
You can use the nozzle to increase airflow in tight
areas.
4 OPERATION
Make sure the blower tube is in position before
operation.
4.1 INSTALL THE BATTERY PACK
Figure 3.
Tube
5
Nozzle
6
Slot
7
Battery release
8
button
WARNING
TIP
WARNING
English
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery
compartment until the battery pack locks into
place.
3. When you hear a click, the battery pack is
installed.
4.2 REMOVE THE BATTERY PACK
Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4.3 START THE MACHINE
Figure 4.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
4.4 STOP THE MACHINE
Figure 4.
1. Release the trigger to stop the machine.
Wait until the engine stops after you stop the
machine.
4.5 CRUISE CONTROL LEVER
Figure 4.
1. Pull the cruise control lever clockwise to increase
the speed. This will lock the speed at the desired
setting.
2. Push the cruise control lever counter clockwise to
decrease the speed.
If you decrease the speed all the way, the unit will
stop and it is necessary to start the machine again.
4.6 TURBO BUTTON
Figure 4.
1. Push the turbo button, the machine is at the
highest speed.
4
WARNING
NOTE
NOTE