GreenWorks GD48AB Manual Del Operario página 6

2. Release the turbo button, the machine is at the
normal speed.
4.7 OPERATION TIPS
• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete
work.
5 MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the
plastic housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
5.1 CLEAN THE MACHINE
CAUTION
The machine must be dry. Humidity can cause risks
of electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
6 TRANSPORTATION AND STORAGE
WARNING
Remove the battery pack from the machine before
transportation and storage.
English
6.1 MOVE THE MACHINE
• Only hold the machine with the handgrip.
6.2 STORE THE MACHINE
• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
7 TROUBLESHOOTING
PROBLEM
The motor
does not start
when you pull
the trigger.
The machine
does not start.
The air does
not flow
through the
tube when you
start the ma-
chine.
5
POSSIBLE SOLUTION
CAUSE
Make sure that
The battery pack you tighlty in-
is not installed stall the battery
tightly. pack in the ma-
chine.
The battery pack Charge the bat-
is out of power. tery pack.
The power
switch is defec-
tive.
Replace the de-
fective parts by
The motor is de-
an approved
fective.
service center.
The PCB board
is defective.
The air inlet or
Remove the
tube outlet has a
blockage.
blockage.
EN