•
Do not leave the cable(s) hanging over the edge of a table or countertop.
•
Do not place the cable(s) on hot surfaces or near oil.
•
Do not tuck the cable(s) under rugs or blankets. Make sure the cable is never in a walkway.
•
Do not move the product by pulling the cord or twist the cord.
•
Before connecting the product, make sure that the mains voltage indicated on the rating
plate matches that of your mains supply.
•
Never leave the product unattended when in use. This may cause a fire hazard or personal
injury.
•
If you are not using the product for a long period of time, turn the product off and unplug it.
•
Make sure you do not trip over the cable(s) and that the cable(s) are not kinked, twisted, or
stuck.
3. INSTRUCTIONS FOR USE
1.
Insert the control panel plug into the product power connector.
2.
Insert the plug into the power outlet and slide the switch from 0 to 1. The display shows the
selected heat setting. The product heats up slowly.
3.
Turn the switch to 1, 2 or 3 to select the desired heat setting.
4.
Turn the switch back to 0 to turn the product off. The display will turn off.
4. TROUBLESHOOTING
Problem
The display does not light up while:
- the control panel is fully
connected to the product,
- the plug is connected to the
power outlet,
- the switch is set to 1, 2 or 3.
5. MAINTENANCE AND CLEANING
Always unplug and remove the control panel from the product by disconnecting it
from the power outlet before cleaning the product.
The control panel should never come into contact with water or other liquids,
otherwise the control panel may be damaged. Use a dry, lint-free cloth to clean the
control panel. Do not use chemical or abrasive cleaners.
Do not reconnect the control panel to the product until the product is completely
dry, otherwise the product may be damaged. Under no circumstances turn on the
product to dry it, otherwise there is a danger of electric shock.
Cause
The safety system
irreversibly disabled the
product.
English
Solution
Please contact our
customer service
department.
21