Publicidad
Idiomas disponibles
Idiomas disponibles
foce] | | eg ale].
-Sierelam
PROGRAMMING
From the AXTO-TY1 harness to the aftermarket radio, connect as indicated:
1. Turn the key (or push-to-start button) to the ignition position and wait until the radio
INSTALLATION
AUDIO LEVEL ADJUSTMENT
comes on. The factory amplifier should come on and you should hear sound at this point.
2. Test all functions of the installation for proper operation, before reassembling the dash.
Note: To ensure that balance and faders are centered, turn volume up 3/4 and shut off vehicle
Red wire to the accessory wire.
DO NOT shut off the radio, prior to shutting off the vehicle.
Blue wire to the power antenna wire.
Black wire to the ground wire.
Yellow wire to the battery wire.
Orange wire to the illumination wire. (if applicable)
Black/White wire connect this to the ground wire if there is noise in the system.
With the key in the off position:
1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.
1. Connect the 16-pin harness with stripped leads, and the AXTO-TY1 harness into the
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
AXTO-TY1 interface.
level; counter clockwise to lower the audio level.
2. Connect the AXTO-TY1 harness to the wiring harness in the vehicle.
3. Once at a desired level, audio adjustment is complete.
REV. 1/3/22 INSTAXTO-TY1
Publicidad
