Panasonic WH-SDC0509L3E5 Manual De Instalación página 19

4. Room sensor: PAW-A2W-TSRT
Install the room temperature sensor to the room which requires
room temperature control.
30
5. Solar sensor: PAW-A2W-TSSO
Use for measurement of the solar panel temperature.
Insert the sensor into the sensor pocket and paste it on the solar
panel surface.
Dimensions (mm)
blue
brown
6. Please refer to the table below for sensor characteristic of the
sensors mentioned above.
Temperature Resistance
(°C) (kΩ)
30 5.326
25 6.523
20 8.044
15 9.980
10 12.443
5 15.604
0 19.70
-5 25.05
-10 32.10
-15 41.45
-20 53.92
-25 70.53
-30 93.05
-35 124.24
-40 167.82
• For optional pump.
Power supply: AC230V/50Hz, <500W
Recommended part: Yonos Pico 1.0 25/1-8: made by Wilo
• For optional mixing valve.
Power supply: AC230V/50Hz (input open/output close)
Operating time: 30s~120s
Recommended part: 167032: made by Caleffi
This section is for authorized and licensed electrician/water system
installer only. Work behind the front plate secured by screws
must only be carried out under supervision of qualifi ed contractor,
installation engineer or service person.
Dimensions (mm)
86
86
black
40
Temperature Resistance
(°C) (kΩ)
150 0.147
140 0.186
130 0.236
120 0.302
110 0.390
100 0.511
90 0.686
80 0.932
70 1.279
65 1.504
60 1.777
55 2.106
50 2.508
45 3.003
40 3.615
35 4.375
WARNING
Network Adaptor F Installation
1. Open the Control Board Cover 6, then connect the cable
included with this adaptor to the CN-CNT connector on the
printed circuit board.
60 • If an Optional PCB has been install in the Indoor Unit, connect
the CN-CNT connector to Optional PCB 9 .
2. Insert a fl at head screwdriver into the slot on the top of the
adaptor and remove the cover. Connect the other end of the
CN-CNT cable connector to the connector inside the adaptor.
Slot
Ø6
3. Pull the CN-CNT cable through the hole in the bottom of the
adaptor and re-attach the front cover to the back cover.
4. Fix the Network Adaptor 6 to Network Adaptor Holder.
Guide the cable as shown in the diagram so that external forces
cannot act on the connector in the adaptor.
Connection examples:
Connector
CN-CNT cable
(Take care not to pinch
the cable)
CN-CNT cable
Network
Adaptor
Holder
Without Optional PCB
CN-CNT cable
Network
Adaptor
Holder
With Optional PCB
19