Publicidad
6 DIAGRAMME ÉLECTRIQUE
RESEAU ÉLECTRIQUE
230V/60Hz
F N
1L1 3L2 5L3 13 A1+
CONTACTEUR
2T1 4T2 6T3 14 A2-
T4
PROTECTEUR
THÉRMIQUE
M1~
T1
60
All manuals and user guides at all-guides.com
1
1
NF
NF
ÉMERGENCE
NC
NC
2
2
3
3
NA
ATTACHÉ
4
NO
4
1
NF
1
DÉTACHE
2
NC
2
SENSEUR
SENSEUR
T4
SENSEUR
The Blade Scraper
This scraper cleans the bone dust or the residues from the blade during the opera on. The
scraper may be removed for cleaning (see item 3.3 cleaning).
2.2.7 Lower Wheel
The Lower Wheel #. 16 (Pic.01) is assembled on the lower bearing sha and fixed by the
staple #. 10 (Pic.01). The staple shall always be placed in the sha slit.
The lower wheel may be removed for cleaning a er removing the blade.(see item 3.3
Cleaning).
2.2.8 Upper Wheel.
The Upper Wheel #.05 (Pic.01) frame has its own sha and bearings.
Therefore the Upper Wheel has to be removed with the sha and bearing for cleaning (see
item 3.3 Cleaning), only a er the Blade has been taken off.
3. OPERATION
3.1 Pre-Opera on
3.1.1 Check if the saw is standing firm in its posi on
3.1.2 Adjust the Blade Guide # 07 (Pic.01) height to meet the meat piece thickness.
3.1.3 Doors and Blade Guard
The upper door #.04 (Pic.01), the Lower Door #. 15 (Pic.01) and the Blade Guard #17
(Pic.01) shall be closed and in their right posi on while the saw is opera ng...
3.1.4 Thickness Guide
SENSEUR
To obtain several slices with the same thickness, adjust the Thickness Guide #.13 (Pic.01) as
desired. Turn the Thickness Guide Handle counter clockwise loosing the Thickness Guide,
and drive it to the desired thickness. Then ght back the handle.
SENSEUR
3.1.5 Control Board.
The ON/OFF Switch # 02 (Pic.01) and the Emergency Bu on Switch #.03 (Pic,01) are placed
on a control board, on the motor housing upper front side.
To turn ON the saw press the ON/OFF Switch (green) bu on to posi on "I"..
To stop the saw opera on press the ON/OFF Switch (red) bu on to posi on "O".
SENSEUR
If an emergency case arises, press the EMERGENCY bu on, immediately stopping the saw
opera on.
3.2 Opera ng process
Before to start the Saw
- Pull totally the Movable Table # 09 (Pic.01) toward the saw front side..
9
Publicidad
