BERGNER BG-50053-CP Instrucciones De Uso página 5

ENGLISH
GENERAL DESCRIPTION
1. Transparent cover
2. Lid
3. Cup
4. Stirring blade base
5. Body
IMPORTANT CAUTION
Read these instructions for use carefully before using the appliance and save them for futher
reference.
● Check if the voltage indicated on the base of the appliance corresponds to the local mains voltage
before you connect the appliance.
● This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
● Children should be supervised to ensure that they do not play with the appliance.
● Do not use the appliance when the mains cord, the plug or other components are damaged.
● Make sure all parts are correctly mounted before you switch on the appliance.
● Never reach into the feeding tube with your fingers or an object while the appliance is running. Only
the pusher is to be used tor this purpose.
● Do not remove the pulp container when the appliance is in operation.
● Do not touch the small cutting blades in the blades in the base of the filter.
● Always unplug the appliance after use.
● If the supply cord is damaged, must be replaced by the manufacture or its service agent or a
similarly qualified person in order to order to avoid a hazard.
● The water temperature should not be over 60°C when cleaning the unit.
● Do not run this unit long-time, otherwise the inner parts will be damaged.
● Do not put the whole or parts of body into water .
● Care shall be taken when handling the sharp cutting blades, emptying the bowl and during cleaning.
● Do not use the appliance if the rotating sieve is damaged.
● Switch off the appliance and disconnect from supply before changing accessories or approaching
parts that move in use.
8
BEFORE FIRST USE
● All parts of the blender are to be thoroughly cleaned before being used for the first time.
● Connect the device to the mains supply.
HOW TO USE BLENDER
1. Check the switch knob on the"0" bit pointer position.
2. Put the cup on to the motor base, and button clockwise.
3. Place the foodstuff you wish to process into the cup.
4. Put the lid on the cup and close securely. Place the measuring cap into the hole in the lid.
5. Switch on the motor base.
SPEED SETTING USE
For light usage with liquids.
1 (Low)
For more solid consistency:
2 (High)
for mixing liquids and solid foodstuffs.
Stop operation.
0
Short, powerful impulse movements.
P (Pulse setting)
(The switch does not permanently engage in the" P " setting. You have to hold the switch in the "P"
setting or push it repeatedly.)
NB: Operate the motor for a maximum of 2 minute or alternating 2 minute
on, then 2 minute off to prevent overheating or consequent damage.
GRINDER
1. Place the dry foodstuff like coffee beans, almonds, peanuts, nuts and more into the grinder base.
2. Put the grinder cover on the grinder base and close securely.
3. Switch on the motor base to proper setting to mill.
HOW TO CLEAN
● The appliance is easier to clean it you do so immediately after use.
● Do not use abrasive cleaning agents, scourers, acetone, alcohol etc. to clean the appliance.
1. Switch the appliance off, remove the plug from the wall socket and wait until the f blade has stopped
running.
2. Turn blender cup to loosen counter-clockwise.
3. Clean these parts with the cleaning brush in warm water with some washing-up liquid and rinse
them under the tap.
4. Clean the motor unit with a damp cloth.
Never immerse the motor unit in water nor rise it under the tap.
9