RIDGID 535 Manual De Operador página 16

535 Manual Pipe and Bolt Threading Machine
Be sure that No. 844 Drive Bar is prop-
WARNING
erly engaged and secured.
8. Supporting 141 Geared Threader, move carriage
and fully engage Drive Link Assembly in die head
mounting hole on carriage. Tighten Set Screw.
9. Attach multiposition oil spout to drive link (Figure
16A and 16B).
If pipe extends beyond machine bed, it
WARNING
should have a pipe support. Be sure that adjusting col-
lar on pipe support stand is locked securely.
10. Support pipe with a pipe support. Position support
approximately 2 1 / feet from threader.
2
11. Insert pipe in threader and center end of pipe in
throat of dies. Tighten workholder with socket wrench.
12. Tighten clamp screw securely with socket wrench.
Figure 16A – 141 Geared Threader Close-Coupled To
New-Style 535 using Drive Link. Note Oil
Spout Attached To Link.
14
Figure 16B – 141 Geared Threader Closed-Coupled to
New-Style 535 Showing Position Of Oil
Spout On Workpiece.
Figure 17A – Geared Threader Saddle Adapter
Figure 17B – Saddle Adapted Mounted on 535 Carriage
Ridge Tool Company