Linea 2000 DOMO DO91201 Manual De Instrucciones página 53

Idiomas disponibles

INSTALLATION

Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the

inside with a wet, lukewarm cloth. Dry the appliance off well.

Let air circulate freely around the cabinet.

Make sure there is sufficient space to open the door.

This cooling unit is not intended for use as a built-in appliance.

Select a place with a strong, level floor.

Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will

cause higher electricity consumption.

Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the

evaporator, and your refrigerator.

Before connecting your refrigerator to the power supply, check that the voltage stated on the rating

label of your appliance corresponds to the voltage in your home. A different voltage could damage the

appliance.

After installation, leave the fridge for 24 hours before turning it on. This way the refrigerant can settle.

Allow the appliance to run empty for 8 hours so the compartment can cool to the appropriate

temperature.

One can level the appliance using the adjustable legs. The adjustable legs can be adjusted by screwing

them in or out of the appliance.

www.domo-elektro.be

Lift

Lower

DO91201