Publicidad
Idiomas disponibles
Idiomas disponibles
DOOR CONVERSION
If you need to hinge your door on the opposite side, it is recommended that you call your local authorised
service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure
the appliance is unplugged and empty.
It is recommended to use a crosshead screwdriver, a flathead screw-driver, a putty knife, a socket wrench
(8 mm) and a wrench (8 mm) (not supplied).
1.
Remove the door racks to prevent damaging them.
2.
Remove the top hinge cover plates.
3.
Loosen the screws of the top hinge and remove the hinge.
4.
Lift the door and place it on a padded surface to prevent it from being scratched.
5.
Loosen the screws ② and ⑤ at the bottom of the door, then remove the support foot ①, the stop
block ④ and the door stop ③ from the bottom. Attach the support foot ① to the right side with
the screw ②. Replace the door stop ③ and stop block ④ on the left side, and tighten the screws ⑤
firmly.
①
②
6.
Carefully tilt the device backwards. Loosen the bottom hinge ③ + ④. Remove the screw cover cap
① and the levelling foot ② from the left side, and attach to the right side.
www.domo-elektro.be
③
④
⑤
DO91201
55
Publicidad
