Descargar Imprimir esta página

Linea 2000 DOMO DO91201 Manual De Instrucciones página 61

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63
TROUBLE SHOOTING
Frequently, a problem is minor and a service call may not be necessary, use this trouble shooting guide for
a possible solution.
Does not work
·
Check connection of power cord to power source.
·
Check that the temperature controller is not in the 0 position.
·
Plug in unit.
·
Use proper voltage.
Cools too frequently
·
The temperature setting is too cool.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
Internal temperature not cold enough
·
Check connection of power cord to power source.
·
Plug in unit.
·
Check setting and adjust as needed.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Allow room for air to circulate around unit.
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
Unusual sounds
·
The appliance is not level. Readjust the adjusting feet and level the unit.
·
The unit is touching a wall or another object. Gently move the appliance.
There is water on the floor.
·
The condensation duct is blocked. See the chapter on cleaning.
·
Too much condensation has formed in the fridge, causing the reservoir to overflow. Too much
condensation is caused by a heat difference. Is the door closed properly? Have you put hot food in the
fridge? Does the seal still close properly?
The door does not close properly.
·
The door seal is deformed. Heat it gently using a hairdryer. The rubber seal will become flexible and
the magnetic strip in the rubber will automatically pull towards the appliance. After cooling, the
rubber stays in that position.
www.domo-elektro.be
61
DO91201

Publicidad

loading