Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
UNPACKING & SET-UP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2.The caster installation with this vacuum, See
CASTER ASSEMBLY for the caster assembly
installation instructions.
3. Before replacing power head, refer to this
manual to ensure you have the proper filters
installed for the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach one of the cleaning accessories
(depending on the cleaning requirements) on
the hose. Twist slightly to tighten the connection.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) to the
extension wands. Twist slightly to tighten the
connection.
8. Plug the cord into the wall outlet. The cleaner is
ready for use.
9. Turn the unit "ON" by pushing the switch from
position "O" to position "I". The "O" is the
"OFF" position and the "I" is the "ON" position.
WARNING: To reduce the risk of injury from
accidental starting, always shut off vacuum and
disconnect the power plug from the wall outlet
before installing any part or cleaning accessory.
WARNING: Do not alter the plug in any way.
If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician to install the proper outlet.
WARNING: To reduce the risk of fire or
explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the
air. Flammable gases or vapors include but are not
limited to: lighter fluid, solvent-type cleaners, oil-
based paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited to: coal,
magnesium, aluminum, and grain or gun powder. Do
not vacuum explosive dust, flammable or
combustible liquids or hot ashes.
Do not use this vac as a sprayer for any flammable
or combustible liquid. To reduce the risk of health
hazards from vapors or dusts, do not vacuum toxic
materials.
WARNING:
The operation of any utility vac can
result in foreign objects being blown into the eyes,
which can result in severe eye injury. Always wear
safety goggles complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before starting operation.
CAUTION: To reduce risk of hearing damage,
wear ear protectors when using the vacuum for
extended hours or when using it in a noisy area.
CASTER ASSEMBLY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2. Attach casters following the instructions below:
a. Invert dust tank, take the caster to align the tank
bottom sinking place. Secure with screws
provided.
b. Return dust tank assembly upright.
WARNING: Never operate the vacuum without
filters installed.
4
Publicidad
