Publicidad
GBR
TECHNICAL SAFETY
Ensure that the connection data on the data plate (voltage and frequency) match the mains electricity supply. It is essential that they match to avoid damage to the
appliance.
Before using the vacuum cleaner, check for any signs of damage. Do not use a damaged appliance: It could be dangerous.
The socket on the vacuum cleaner (depending on model) must only be used for the brush specified for use with this appliance.
Do not pull or carry the vacuum cleaner by the cable and be careful not to damage the cable when withdrawing the plug from the socket.
Keep the cable away from sharp edges and do not let it be squashed, for example, under a door.
Avoid running the vacuum cleaner over the cable. This could damage the cable, plug or socket and pose as a safety hazard.
The appliance must not be used if any of these have suffered damage.
If the cable is damaged it must be replaced together with a complete cable rewind. For safety reasons this must only be done by authorized service technician.
Otherwise the guarantee will be invalidated. Repairs should only be carried out by authorised service technician.
Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work.
It is important to switch the vacuum cleaner off before changing over accessories.
Do not let the vacuum cleaner get wet.
Clean only with a dry cloth or slightly damp cloth when disconnected from the mains supply.
If moisture gets into the appliance, there is a risk of electric shock.
Do not immerse the hose in water for cleaning. The vacuum cleaner hose should be checked regularly and must not be used if damaged.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
ATTENTION:
Turn OFF other appliances while vacuuming to avoid overload of electric source
Don't absorb water or other liquid.
Don't place it near heat source.
PREPARATION
Let the end of the hose insert into the air intake socket until clicking position.
.
8
MT-1351
Publicidad
