Publicidad
FIG. 2
2) Apply an even coat of glue in the remaining holes of the two pairs of legs. Insert the remaining
Stretchers (CC) and press them fi rmly together. See FIGURE 2. You have now completed the un-
dercarriage assembly. Immediately proceed to Step 3.
TO ATTACH LEG ASSEMBLY TO SEAT
3) Apply an even coat of glue into the holes in the Seat (D). Take the undercarriage assembly and tap
legs fi rmly in place into the seat holes. See FIGURE 3. After all legs are in place, set the stool on
a hard fl at surface to make sure that the legs are even, and the stool does not wobble. If the stool
does wobble, determine which two legs seem to be short (they will be diagonally across from each
other). Turn the stool over and pull these legs toward each other. Check to see if the wobble has
been corrected. Repeat this step until stool sits level. Allow the glue to set 4 to 6 hours.
CC
CC
FIG. 3
D
PAGE 3 — 170Wa (Rev. 12/06)
Publicidad
