Whittier Wood Furniture Bistro 174Wb Instrucciones Para Armar página 4

3) Insert #8 x 1¼" Pan Head Screws (O) through pocket holes in side aprons (Ha) into Front and Back
Leg Assemblies (W & V).
Lay the Seat (J) face down on a clean protected surface, with the back of the seat hanging over the edge.
Center the leg assembly on the seat and making sure that the seat remains in contact with the back legs,
fasten in place with 2¾" Black Screws (R) through the holes in the front and side aprons into the seat.
Now slide the Back Apron (I) toward the back of the seat between the side aprons. Make sure that
no part of the back apron hangs over the back of the seat, fasten the back apron to the seat with 2¾"
Black Screws (R). See FIGURE 3.
FIG. 4
4) For added strength screw a 1¼" Black Screw (S) through the bottom of both lower side stretchers into the
front and back legs. See FIGURE 4.
PAGE 4 — 174Wb & 175Wb & 177Wb & 178Wb (Rev. 01/08)
R
W
1/2"
To insert screw at proper angle, the
screw head should be approximately
1/2" from the nearest surface when
starting screw.
S
S
R
Ha
R
O
O
R
R
J
Ha
S
S
V
I
R
FIG. 3