Publicidad
ZD
x 2
ZE
x 2
ZF
x 2
8. Hammer Tack Glides (ZD) into the bottom of the Back Legs (I).
Thread the Adjustable Glides (ZE) on the Plastic Inserts (ZF) and tap into holes in the bottom of
the front legs.
V
x 6
I
I
FIG. 9
9. Spread glue on the two sides of the notch and the top edge of one Back Leg (I). With the notch
snugly against the Left Side and Bottom Shelf, and the leg flush with the back edge of bottom
shelf, insert two #8x1
DO NOT INSERT SCREWS SO DEEP THAT THE SCREW HEAD GOES BELOW THE
SURFACE OF THE LEG!
5
Insert a #8x1
/
" Black Screw (V) down through the predrilled hole in the bottom shelf into the leg.
8
Repeat for the other Leg on the Right Side.
ZD
ZD
I
FIG. 8
V
V
FIG. 9A
5
/
" Black Screws (V) through the predrilled holes in the leg into the side.
8
I
ZE
ZF
ZF
FIG. 8A
I
FIG. 9B
744W — Page 7
ZE
V
Publicidad
